  2000 Watt DC to AC Modified Sine Wave Power Inverter 12 Volt
Modified Sine Wave Power Inverters represent the most economical solution for powering a large number of appliances. The waveform produced by a Modified Sine Wave Power Inverter is "Square" resembling a set of steps whereas the waveform produced by utility companies is smooth much like a curvy road. Therefore because of the type of waveform the Modified Sine Wave Power Inverters produce they are suitable for most applications. Modified Sine Wave Power Inverters are more efficient in converting battery power to AC. So if you’re looking to make a pot of coffee run a heater or air conditioner or appliances that can withstand occasional electrical noise a Modified Sine Wave Inverter is a cost-effective solution. To select the right inverter first determine what devices you would need to run in the event of a power outage. Then select the appropriate inverter that can carry the combined wattage requirements of these devices. Some appliances have a start up amperage. Powerful features such as volt meter watt meter 8 replaceable fuses and thermally controlled fan. This inverter has been tested in our facility to continuously run at 2000 watts.
Features
- 2000 Watts max continuous power
- Modified sine wave
- Volt meter on front panel to monitor your battery voltage
- Port for optional remote switch
- LED (green/red) indicating ready/fault
- Dual AC Receptacles that can be split with a separate splitter if more outlets are needed. Outlets are protected by rubber covers.
- On/Off Switch
- Over Temperature protection
- Over Load protection
- Three cooling fans operation thermally controlled
- Internally fuse protected
- Soft Start Technology
- Isolated Ground, no risk of the inverter burn-out due to grounding the neutral line
- ac output short circuit protection
- Auto reset on most fault conditions
- Aluminum case for optimal cooling
- Pre-wired for remote on/off switch
- Pre-slotted mounting plate
- Instruction manual
- Free 1 year tech support
- 1 Year Warranty Parts and Labor
Specifications
- Continuous output power: 2000 Watts
- Surge power capability (peak power): 4000 Watts
- dc input / operating voltage: 10 to 15 Volts · Output voltage: 120 Volts ac +/- 10%
- Output wave form: modified sine wave with phase correction
- Output frequency: 60 Hz +/- 1 Hz
- Battery low voltage alarm: 11.5 +/- 0.5 Volts
- Battery low voltage shutdown: 10.5 +/- 0.5 Volts
- No load current @ 12V: 1.2 Amps
- Full load efficiency: 90%
- 1/3 load efficiency: 95%
- No load minimum operating temperature: -15 degrees Celsius
- Full load maximum operating temperature: 55 +/- 5 degrees Celsius (automatic shutdown)
- AC Output Socket Type: quadruple Type 2 -3 prong
- High input voltage protection: 17V
- Low input voltage shutdown: 10.5V
- Internal fuse protection
- Product size (L x W x H): 10.75"X 9.75"X 3.75"
- Unit Weight: 7.2 lbs
- Boxed Weight: 10 lbs
- UL maximum recommended per outlet 1500W
|
:
